top of page
Lemans Bowl Rebuild Kit

Lemans Bowl Rebuild Kit


This kit includes the parts needed to rebuild your Lemans Bowl carburetor. These are the exact parts that are used in a Air Fuel Spark restoration. 


 This kit is appropriate for any of the Ford performance carbs with Lemans bowls. 

List 2919, 2953, 3255, 3255-1, 2953, 3259, and 3259-1.


The Kit contains:

Amount    Part Description    

2    Needle/Seat    Correct style needle/seat, viton tipped.  Three pieces, housing, needle,   


1    8.5 Power Valve correct power valve for each metering block

2    Gasket Metering Block Nonstick gasket used between main body and metering  block

2    Gasket Fuel Bowl. Nonstick gasket used between fuel bowl and metering block

8    Gasket Fuel bowl screw each bowl screw requires one of these

1    Diaphragm, accelerator pump diaphragm

1    Gasket, 1 11/16 Throttle body throttle body gasket for between baseplate andmain         


1    Diaphragm, Vacuum Secondary    correct length secondary diaphragm

2    Gasket VS Pot or Choke. 1 used between vacuum housing and main body, one is 

            for choke seal

2    Gasket, Accelerator pump nozzle    1 for each nozzle screw, and 1 under each nozzle

2    Idle Mixture screw    new idle mixture screw

3    Teflon ribbon, wide    3 each for secondary shaft

1    Teflon ribbon, thin    1 each for secondary shaft

6    Metering block well plug. If you removed the idle well plug to clean the idle well, 

             this is a new plug to seal it

2    Cork seals for mixture screw    new extra thick cork mixture screw seal

1    Gasket, Power valve    correct gasket for the power valve included

1    Gasket, choke cap    for between choke cap and choke casting

2    choke plate screw    new screws as the old ones are typically damaged on removal

1    Baseplate Gasket4 hole gaskets for between carburetor and intake manifold

1    Air Cleaner Gasket    Extra thick gasket for between air cleaner and carburetor. 

1    Cotter pin    retains secondary closing link

1    Hairpin clip for choke rod    retains choke rod to choke housing

1    E clip 1/4inch    to retain accelerator pump lever

1    E clip 3/16    e clip to retain secondary diaphragm rod to secondary shaft

1    #6 washer    optional washer for secondary closing link

8    Brass screw throttle plates    Brand new throttle plate screws.  Self binding style 

            screws, blue loctite is still advised



    bottom of page